Hvad skal jeg gøre, hvis LED-displayet kun er halvt lyst? I virkeligheden er mange situationer som denne overhovedet umulige at starte. Hvis vi vil løse denne grund, skal vi forstå de specifikke årsager, der får LED-skærmen til at være halvt slukket og halvt lys, og derefter analysere og fejlfinde gennem rimelige trin og derefter løse problemet fra kilden. . Der er normalt følgende årsager til den halve-lysstyrke på LED-skærmen. Fejlfindingsmetoderne er som følger:
LED display
1. Linen er løs
(1) First, check whether the serial cable used to connect to the controller is loose or has fallen off. If it turns black during the initial loading process, it is probably because the communication line was interrupted during the communication process due to the loosening of the communication line. Therefore, the screen turned black. Check it first, but it is important to solve the problem quickly.
(2) Check and confirm whether the HUB distribution board connected to the LED screen and the main control card is tightly connected and whether it is plugged in reverse.
2. Strømforsyningsproblem
Please make sure that all hardware including the control system has been powered on correctly. Whether the power light is flashing, whether the power supply is faulty, it is worth noting that this phenomenon is usually prone to occur when using a low-quality power supply.
LED display
3. LED-enhedskortforbindelsesproblem
(1) The longitudinal direction of several consecutive boards is not bright, check whether the power supply of this column is normal.
(2) If several consecutive boards do not light up in the horizontal direction, check whether the cable connection between the normal unit board and the abnormal unit board is connected; or whether the chip 245 is normal.
Winbond Ying LED-skærm
4. Softwareindstillinger eller lampeproblemer
If there is a clear separation between the two, the possibility of software or settings is high; if the transition between the two is even, it may be a lamp problem. The above are the reasons and solutions for the LED display that is half bright and half not bright. Check out the most likely causes one by one and locate them quickly. If it is due to a hardware failure or the problem cannot be confirmed, please contact your service manufacturer for technical support.
